AVer IP Camera User Manual download pdf (Page 33)

3.3.3 Wireless Setup

The Wireless IP Camera supports 802.11g protocol that is including WEP or WPA basic security settings. The

wireless camera also supports WPS (Wi-Fi Protected Setup) for quick and easy wireless security setup. Click

Save to complete the configuration, Cancel to discard the setting.

 Enable Wireless: Mark to enable wireless function.

 Site Survey: When wireless function is enabled, the camera system will automatically scan the available

wireless AP devices on the network. Select the wireless AP from drop-down list to connect. When user

selects the wireless AP device, the degree of signal will be display at bottom of the screen. Click Rescan

to search available AP devices again.

 SSID: SSID (Service Set Identity) is the ID assigned to the wireless AP(Access Point). The camera

system will auto-detect and display the SSID of wireless AP.

 Wireless Mode: Select the Infrastructure (default) as the wireless mode. If your network is using a

network connection directly between the devices without wireless AP, and then, select the Ad-Hoc as the

wireless mode.

 Channel: Select the channel for communicate with the wireless AP or select Auto. Then channel

selection is depending on the regulatory region where the AP device is sold.

 Authentication: Select the type of authentication that user has used on the network - Open, Shared,

WPA-PSK, or WPA2-PSK.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 67 68

No comments

AVer IP Camera User Manual Page 33